![]() And if that is not good, your bead board will come loose and fail. As the weakest part of the equation is the plaster being stuck to the lath. This way if you ever decide to remove it you do not end up having to replace the plaster wall, only need to patch it.Īlso if the plaster is in poor shape, consider that the paneling will not stick to it very well. ![]() If you do this, I would then suggest that you forgo the adhesive and just use panel nails to hold it on the wall. Using a 3/16-inch masonry bit, drill a hole in the plaster about 2 inches from the crack. The paneling will cover over the opening you cut. ![]() A quick visual inspection can also tell you whether you have lath and plaster construction or not. Be careful when working with lead-based paint. With plaster walls, there is a high probability that the walls paint contains lead. Lead-based paint should not be inhaled or ingested. Lead-based paint has been shown to cause birth defects and affect development in children. If it sounds hollow, then it’s likely drywall if it sounds solid, then chances are it’s plaster. Paint applied before 1978 may be lead-based paint. To do this, tap the wall surface with your knuckle. Simply take a level and mark the walls where each stud is located. Tap Test: A tap test is a simple way to differentiate between plaster and drywall. Apply the sticky part to your wall, ensuring it aligns vertically with your level spot. Starting from the top of your wall, peel off the backing of the wallpaper for about 10 to 20 inches. This will expose the wall joists along the entire wall. The application process for peel and stick wallpaper, as the name suggests, is wonderfully straightforward. ![]() Still another method is to cut out a one or two inch slot along the entire wall about six inches below the top of the paneling. (Most lath is 1¼ wide, spaced ¼ apart, and laid horizontally on walls.) If there are existing damage holes extending down to the lath, drill 3/16 holes 1½ away from the edge of the hole, around the perimeterone in. You can pour good quality paint into a pan and use a roller to evenly apply the first coat of paint to the plaster walls. Along the crack’s length, drill 3/16 holes on both sides, about 1½ apart, in every other lath. If things were somewhat ok you can then measure every 16 inches from there and you should be on each stud. Priming and Painting the Plaster Walls: Apply a high quality primer on the plaster wall and allow the primer to dry for the maximum amount of time. Just use tiny brad nails and you should be fine.Ī way of guessing where the studs are if you are still concerned is to remove one of the outlet covers and find out what side the wall stud is located on the box. The wood lath in the plaster will be enough to support the nails while the adhesive hardens. Woodbridge Environmental on Jul 18, 2012 ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |